Application & Storage

Preparation for Application

Prep and file nails (including cleaning/removing cuticles) for a smooth surface prior to application.

Set up your UV/LED lamp to prepare for the curing process (do not use the light unless curing).


Application Process

1. Shake each bottle before use to blend.

2. Apply a thin layer of the base coat evenly onto the nail surface and cure in the UV/LED lamp for 10 seconds.

3. Apply a thin and even first coat of colour nail polish and cure in the UV/LED lamp for 120 seconds (2 minutes for UV, LED 30-60 seconds).

4. Apply a second thin and even coat of colour nail polish and cure in the UV/LED lamp for 120 seconds (2 minutes for UV, LED 30-60 seconds).

5. Apply a thin even layer of top coat and cure in the UV/LED lamp for 120 seconds (2 minutes for UV, LED 30-60 seconds).

6. Wipe nails carefully with an isopropyl alcohol wipe to remove any residue and provide that high gloss shine.

7. Repeat the process on the other hand.


Preparation for Removal

Ensure you have your aluminum foil and/or removal wraps, cotton pads/balls and pure acetone prepared.

Cut out the rectangular shaped pieces of aluminum foil (e.g. 5cm x 10cm)  - one for each nail which requires the polish removal.

The removal process is best done over a small towel (to prevent acetone  dripping onto any surfaces).


Removal Process

1. Soak a cotton pad/cotton ball and/or removal wrap with acetone and place directly onto the nail.

2. Wrap the rectangular shaped aluminum foil around your fingertip and nail and squeeze to form a 'finger cap'.

3. Leave on for approximately 10 minutes.

4. Remove the aluminum / wrap from your fingers.

5. Using a dab of the pure acetone on a cotton pad/ball, give each finger a final wipe to remove any remaining residue.


Nail Gel Polish Storage

Shake the bottle thoroughly before each use to disperse the solvents which helps prevent evaporation and thickening.

Close the cap firmly when not in use. This will prevent solvent from evaporating in between services. It may be necessary to clean the neck of the bottle after use to ensure a tight closure.

Do not expose the bottle to light without the cap firmly in place. Exposure to light can begin the curing process; this includes sunlight and table lamps.

Replace the cap when you are not actually applying the product. This limits evaporation as well as exposure to light.

Use Nail Gel Polish when the bottle is at room temperature. This will insure good consistency for application and eliminate fast evaporation of the solvents.